Lots of unknowns for PCB!!! <\/p>\n
Can we drill holes and put in wires, or must we use the template that's called 'wire' to make a wire connection? What is the pin arrangement for RF? What this and that?<\/p>\n
Ok, while typing this, suddenly, I remember. Use separate connectors for the RF. The separation is to be in the number of pins that it occupies on the breadboard. Yeah that should be the way for the PCB thing. Lol.<\/p>\n
Ok, I have a bit more to go, before I can say that PCB is done. Done, but is it good? My PCB designed all depends on holes… No hole, and I can just throw the whole project out of the window, and start protesting. How can we be limited by the number of parts used…<\/p>\n
That's just too bad then. See how on Monday. Have to clear all the doubts before any ultimate PCB design. Wahaha…<\/p>\n
Ding ding dong… ding ding dong… it's 1st October, and the Alarm goes off. <\/p>\n
And 1 more thing: Happy Children's Day~<\/p>\n","protected":false},"excerpt":{"rendered":"
Lots of unknowns for PCB!!! Can we drill holes and put in wires, or must we use the template that's called 'wire' to make a wire connection? What is the pin arrangement for RF? What this and that? Ok, while … Continue reading